Effect of Rotation Number on Heat Transfer Characteristics of a Row of Impinging Jets in Confined Channel

Authors

  • Thantup Nontula Department of Mechanical Engineering, Faculty of Engineering, Prince of Songkla University, Hatyai, Songkhla 90110, Thailand
  • Natthaporn Kaewchoothong Department of Mechanical Engineering, Faculty of Engineering, Prince of Songkla University, Hatyai, Songkhla 90110, Thailand
  • Wacharin Kaew-apichai Department of Computer Engineering, Faculty of Engineering, Prince of Songkla University, Hatyai, Songkhla 90110, Thailand
  • Chayut Nuntadusit Energy Technology Research Center (ETRC), Prince of Songkla University, Hatyai, Songkhla 90110, Thailand

DOI:

https://doi.org/10.37934/arfmts.77.1.161171

Keywords:

Impinging jets, Rotation number, Heat transfer, Thermochromic liquid crystals

Abstract

Jet impingement has been applied for internal cooling in gas turbine blades. In this study, heat transfer characteristics of impinging jets from a row of circular orifices were investigated inside a flow channel with rotations. The Reynolds number (Re) based on the jet mean velocity was fixed at 6,700. Whereas, the rotation number (Ro) of a channel was varied from 0 to 0.0099. The jet-to-impingement distance ratio (L/Dj) and jet pitch ratio (P/Dj) were respective 2 and 4, Dj is a jet diameter of 5 mm. The thermochromic liquid crystals (TLCs) technique was used to measure the heat transfer coefficient distributions on an impingement surface. The results show that heat transfer enhancement on a jet impingement surface depended on the effects of crossflow and Coriolis force. The local Nusselt number at X/Dj?20 on the leading side (LS) was higher than on the trailing side (TS) while heat transfer on the LS at 20?X/Dj?40 gained the lowest, compared to on the TS. The average Nusselt number ratios ( ) on the TS at Ro = 0.0049 gave higher than on the LS of around 2.17%. On the other hand, the  on the TS at Ro = 0.0099 was less than the LS of about 0.08%.

References

Ligrani, Phillip M., and Gazi I. Mahmood. "Variable property Nusselt numbers in a channel with pin fins." Journal of Thermophysics and Heat Transfer 17, no. 1 (2003): 103-111. https://doi.org/10.2514/2.6740

Siddique, Waseem, Naveed Ahmed Khan, and Inamul Haq. "Analysis of numerical results for two-pass trapezoidal channel with different cooling configurations of trailing edge: The effect of dimples." Applied Thermal Engineering 89 (2015): 763-771. https://doi.org/10.1016/j.applthermaleng.2015.06.067

Chen, Yu, Y. T. Chew, and B. C. Khoo. "Heat transfer and flow structure in turbulent channel flow over protrusions." International Journal of Heat and Mass Transfer 66 (2013): 177-191. https://doi.org/10.1016/j.ijheatmasstransfer.2013.07.014

Wang, Chen, Zhongliang Liu, Guangmeng Zhang, and Ming Zhang. "Experimental investigations of flat plate heat pipes with interlaced narrow grooves or channels as capillary structure." Experimental Thermal and Fluid Science 48 (2013): 222-229. https://doi.org/10.1016/j.expthermflusci.2013.03.004

Kreith, Frank, and David Margolis. "Heat transfer and friction in turbulent vortex flow." Applied Scientific Research, Section A 8, no. 1 (1959): 457-473. https://doi.org/10.1007/BF00411769

Han, Je-Chin, and Hamn-Ching Chen. "Turbine blade internal cooling passages with rib turbulators." Journal of Propulsion and Power 22, no. 2 (2006): 226-248. https://doi.org/10.2514/1.12793

Chupp, Raymond E., Harold E. Helms, Peter W. McFadden, and Tony R. Brown. "Evaluation of internal heat-transfer coefficients for impingement-cooled turbine airfoils." Journal of Aircraft 6, no. 3 (1969): 203-208. https://doi.org/10.2514/3.44036

Kaewchoothong, Natthaporn, Kittinan Maliwan, Kenichiro Takeishi, and Chayut Nuntadusit. "Effect of rotation number on flow and heat transfer characteristics in serpentine passage with ribbed walls." Journal of Mechanical Science and Technology 32, no. 9 (2018): 4461-4471. https://doi.org/10.1007/s12206-018-0843-z

Kaewchoothong, Natthaporn, Makatar Wae-Hayee, Passakorn Vessakosol, Banyat Niyomwas, and Chayut Nuntadusit. "Flow and heat transfer characteristics of impinging jet from expansion pipe nozzle with air entrainment holes." In Advanced Materials Research, vol. 931, pp. 1213-1217. Trans Tech Publications Ltd, 2014. https://doi.org/10.4028/www.scientific.net/AMR.931-932.1213

Nuntadusit, C., M. Wae-hayee, and N. Kaewchoothong. "Heat transfer enhancement on a surface of impinging jet by increasing entrainment using air-augmented duct." International Journal of Heat and Mass Transfer 127 (2018): 751-767. https://doi.org/10.1016/j.ijheatmasstransfer.2018.06.130

San, Jung-Yang, and Mao-De Lai. "Optimum jet-to-jet spacing of heat transfer for staggered arrays of impinging air jets." International Journal of Heat and Mass Transfer 44, no. 21 (2001): 3997-4007. https://doi.org/10.1016/S0017-9310(01)00043-6

Esposito, Eric Ian. "Jet impingement cooling configurations for gas turbine combustion." PhD diss., Louisiana State University, 2006.

Geers, L. F. G., M. J. Tummers, T. J. Bueninck, and K. Hanjali?. "Heat transfer correlation for hexagonal and in-line arrays of impinging jets." International Journal of Heat and Mass Transfer 51, no. 21-22 (2008): 5389-5399. https://doi.org/10.1016/j.ijheatmasstransfer.2008.01.035

Elston, Cassius A., and Lesley M. Wright. "Leading Edge Jet Impingement Under High Rotation Numbers." Journal of Thermal Science and Engineering Applications 9, no. 2 (2017): 021010. https://doi.org/10.1115/1.4035892

Parsons, J. A., J. C. Han, and C. P. Lee. "Rotation effect on jet impingement heat transfer in smooth rectangular channels with four heated walls and radially outward crossflow." Journal of Turbomachinery 120, no. 1 (1998): 79-85.https://doi.org/10.1115/1.2841392

Lamont, Justin A., Srinath V. Ekkad, and Mary Anne Alvin. "Effects of rotation on heat transfer for a single row jet impingement array with crossflow." Journal of Heat Transfer 134, no. 8 (2012). https://doi.org/10.1115/1.4006167

Yang, Li, Kartikeya Tyagi, Srinath Ekkad, and Jing Ren. "Influence of Rotation on Heat Transfer in a Two-Pass Channel With Impingement Under High Reynolds Number." In ASME Turbo Expo 2015: Turbine Technical Conference and Exposition. American Society of Mechanical Engineers Digital Collection. https://doi.org/10.1115/GT2015-42871

Chang, Shyy Woei, and Kuo-Ching Yu. "Thermal performance of radially rotating trapezoidal channel with impinging jet-row." International Journal of Heat and Mass Transfer 136 (2019): 246-264. https://doi.org/10.1016/j.ijheatmasstransfer.2019.02.098

Kaewchoothong, Natthaporn, Kittinan Maliwan, Kenichiro Takeishi, and Chayut Nuntadusit. "Effect of inclined ribs on heat transfer coefficient in stationary square channel." Theoretical and Applied Mechanics Letters 7, no. 6 (2017): 344-350. https://doi.org/10.1016/j.taml.2017.09.013

Kaewchoothong, Natthaporn, Pathomporn Narato, and Chayut Nuntadusit. "Experimental investigation of the heat transfer characteristics and thermal performance inside a ribbed serpentine channel during rotational effects." Experimental Thermal and Fluid Science 111 (2020): 109973. https://doi.org/10.1016/j.expthermflusci.2019.109973

Moffat, Robert J. "Describing the uncertainties in experimental results." Experimental Thermal and Fluid Science 1, no. 1 (1988): 3-17. https://doi.org/10.1016/0894-1777(88)90043-X

Downloads

Published

2021-04-23

How to Cite

Nontula, T., Kaewchoothong, N., Kaew-apichai, W., & Nuntadusit, C. (2021). Effect of Rotation Number on Heat Transfer Characteristics of a Row of Impinging Jets in Confined Channel. Journal of Advanced Research in Fluid Mechanics and Thermal Sciences, 77(1), 161–171. https://doi.org/10.37934/arfmts.77.1.161171
صندلی اداری سرور مجازی ایران Decentralized Exchange

Issue

Section

Articles

Most read articles by the same author(s)

فروشگاه اینترنتی