@article{Abd Rahman_Suzairin MD Seri_Nor Zelawati Asmuin_Ishkrizat Taib_Nur Syakirah Rabiha Rosman_2021, title={Response Surface Methodology (RSM) Approach for Optimizing the Actuator Nozzle Design of Pressurized Metered-Dose Inhaler (pMDI)}, volume={13}, url={https://www.akademiabaru.com/submit/index.php/cfdl/article/view/3985}, DOI={10.37934/cfdl.13.7.2744}, abstractNote={<p>Recently, a remarkable scientific interest in the inhalation therapy for respiratory disease was spiked attributed to the growing prevalence of asthma, chronic obstructive pulmonary disease (COPD), and coronavirus disease 2019 (COVID-19) pandemic. A pressurized metered-dose inhaler (pMDI) is the best option by providing fast and efficient symptomatic relief within the lung. However, the rapid development of new inhalation devices could be critical in this competitive environment, and optimizing the inhalation devices could be costly and time-consuming. Therefore, the computational fluid dynamic (CFD) approach was used to shorten the development time. In this study, response surface methodology (RSM) in ANSYS version 19.2 was introduced to discover the optimal design for the actuator nozzle to increase the performance of pMDI. Three (3) parameters (orifice diameter, length, and actuator angle) were optimized, and the best design was selected according to the analysis of particle tracking. The analysis of spray plume was also conducted and compared to analyze the spray plume characteristic produced by three designs. The result showed that RSM generated three (3) models for the new design of the actuator nozzle (Design A, Design B, and Design C). Among three (3) designs, actuator nozzle design C showed the highest injection particle number (232457) and the only one that produced maximum particles velocity magnitude in the acceptable ranges (35.67m/s). All three designs showed a similar pattern as maximum particle velocity magnitude decreased along the axial length until they match the air velocity (0.03-0.04 m/s). Furthermore, the spray plume length, angle, and width were observed to increase linearly with the decreasing maximum particle velocity magnitude. Thus, this study suggested that design C might have the potential as a new actuator nozzle to develop future pMDI to relieve the respiratory condition.</p>}, number={7}, journal={CFD Letters}, author={Abd Rahman, Muhammad Faqhrurrazi and Suzairin MD Seri and Nor Zelawati Asmuin and Ishkrizat Taib and Nur Syakirah Rabiha Rosman}, year={2021}, month={Aug.}, pages={27–44} }